GPRS with Nokia 9300i, Gentoo and China mobile

Perhaps somebody else will find this useful. The relevant part of my /etc/conf.d/net:

(assuming Bluetooth works)

### GPRS ###

config_ppp0=( "ppp" )

link_ppp0="/dev/rfcomm0"

pppd_ppp0=(
        "noauth"        # Do not require the peer to authenticate itself
        "nomagic"
        "debug"
        "local"         # Ignore carrier detect signal from the modem

        "defaultroute"  # Make this PPP interface the default route
        "usepeerdns"    # Use the DNS settings provided by PPP

        "lcp-echo-interval 15"  # Send a LCP echo every 15 seconds
        "lcp-echo-failure 3"    # Make peer dead after 3 consective
                                # echo-requests

        "lock"                          # Lock serial port
        "115200"                        # Set the serial port baud rate
        "crtscts"                       # Enable hardware flow control
)

chat_ppp0=(
        'TIMEOUT' '5'
        'ECHO' 'ON'
        'ABORT' '\nBUSY\r'
        'ABORT' '\nERROR\r'
        'ABORT' '\nNO ANSWER\r'
        'ABORT' '\nNO CARRIER\r'
        'ABORT' '\nNO DIALTONE\r'
        'ABORT' '\nRINGING\r\n\r\nRINGING\r'
        '' '\rAT'
        'TIMEOUT' '12'
        'SAY' 'Press CTRL-C to close the connection at any stage!'
        'SAY' '\ndefining PDP context...\n'
        'OK' 'ATH'
        'OK' 'ATE1'
        'OK' 'AT+CGDCONT=1,"IP","cmnet"'
        'OK' 'ATD*99#'
        'TIMEOUT' '22'
        'SAY' '\nwaiting for connect...\n'
        'CONNECT' ''
        'SAY' '\nConnected.'
        'SAY' '\nIf the following ppp negotiations fail,\n'
        'SAY' 'try restarting the phone.\n'
)

Leave a Reply

Your email address will not be published. Required fields are marked *